• News
Conair's new system auto-tracks resin inventory changes
Source:Adsale Plastics Network    Editor:JK    Date:29.May.2020

The new TrueRate intelligent inventory tracking system from Conair automatically tracks changes in the inventories of up to 500 different user-specified resins or flowable powders in a processing plant. Developed as an alternative to the use of single-component batch blenders for resin inventory measurement, the new TrueRate system utilizes highly accurate gravimetric measurement.

 

The TrueRate system is available in two sizes, consisting of an 8-inch weighing ring equipped with two load cells, or a 12-inch ring equipped with three. Both configurations connect to a separate electrical control panel containing a PLC.


1_web.jpg

Conair TrueRate system


The weighing ring is mounted below a material loader or receiver but above a container or bin, where it uses resin information provided by the user to precisely calculate the change in weight of the loader/receiver before it discharges the material through the ring and into the container.

 

The system can operate in two modes:

 

  • In default or “totalizer” mode, the TrueRate system continuously and automatically measures the total resin flow through the receiver to a bin or container below. While doing so, it can display the weight for each load cycle, tabulate a running total (in lbs or kgs), and calculate the total throughput rate for a period of time (lb/hr or kg/hr).


  • In job (active) mode, the system adds an optional discharge valve to the weighing ring. This enables the TrueRate system to meter and dose a specified amount of material from the receiver mounted above into a bin or vessel located below.


2_web.jpg

Conair TrueRate Weigh Ring Control


The system senses the amount of material accumulating in the vessel and uses a pneumatic cylinder to close the discharge valve as soon as the correct amount has been dispensed. The cylinder reopens the valve and the receiver cycle resumes when the TrueRate is ready to measure the next batch.

 

The system can be programmed and controlled in three ways: with an optional 4.3-inch touchscreen built into the system’s electrical control panel, with a Windows-based PC running a virtual network client viewer connected via Ethernet cable to the panel, or with both. Mode selection and programming is very simple.

 

So too is connecting the TrueRate system to SmartServices, Conair’s cloud-based Industry 4.0 solution for auxiliary equipment monitoring, management, and analysis. All that is needed is a SmartServices hub and an Ethernet cable connected to the TrueRate system’s electrical control panel.

 

“TrueRate is a new and elegant way to track and regulate the receipt, flow, and usage of valuable resins and flowable powders throughout a plastics processing facility,” says Alan Landers, Conair’s Product Manager for Blending.

Like

0

Leave A Comment

Submit

All Comments

Articles You'll Like
Hot Pictures